ĭraw the ribs with the pen and then weld them to the sub-assembly (see video).
Use the sub-assembly to sketch the 3x front profile ribs with a pencil. Use the sub-assembly to sketch the side rib (thick, structural bar) with a pencil. Heating the skirt can help it conform to the round bottom profile. ĭraw the wavy skirt with the pen and then weld it to the sub-assembly.Use the sub-assembly to sketch the front wavy skirt of the Ghost with a pencil. “Weld” (attach) the front profile to the bottom profile using the 3D pen, to create a sub-assembly. Then stand up the front profile and sketch half the bottom profile with a pencil. In the video I found it helpful to trace over wax paper, so the filament did not stick to the paper. Use the printed out image to trace over with a 3D pen, to create the front profile of the Ghost.** Finally take care and the proper precautions when using an dangerous equipment that this Instructable requires. Printing out the steps below and following along with the video will help a lot. The eyes and frown are heated and then applied to the appropriate side.
The red and blue halves are epoxied together.The eyes and frown are also made separately.The red and blue halves of the ghost are made separately.
#Pac man ghost pumpkin template how to
Please note that I made a time-lapse video of the full process, so you can see all the little details on how to make this in the following video:Īffiliate links to the exact products I used to make this are in the video description.Ī high level overview of how to make this is:
0 kommentar(er)
